New Denim Circle Skirt

Just over a year ago I made myself a denim circle skirt. I’ve worn it loads, it goes with everything and I love it!

I wore it a lot during Me Made May and mentioned that there were a few issues with it and that I wanted to make a replacement.

The waistband is too loose so I added belt loops – but even with a belt it drifts down and I feel uncomfortable in it. It only has one pocket because I put the zip in the side seam at the other side. And the zip is a bit wonky!

Here’s my second attempt!

I decided to go for a paler denim because I fancied something different and I know I’ll wear it a lot in Spring/Summer. I’m also planning to make a longer dark denim skirt to wear with boots in the winter… maybe with a gathered waist rather than a full circle.

It still isn’t perfect, but it’s a much better fit around the waist and has two pockets! I promised that I would do a quick guide to making a circle skirt once I had made a new one… so here it is:

  • Start by measuring your waist circumference and required skirt length.
  • Divide your waist circumference by pi (3.14 will do!) to find your diameter and then half that to find your radius. Make a note of these measurements!

I made the above skirt using a half circle for the front and two quarter circles at the back with a centre seam and invisible zip (which I’m not showing you… it’s very neat but definitely not invisible!). It also has a pocket in each side seam. If that’s what you want to make then continue as follows:

Start by making a paper pattern (I used brown parcel paper).

Front

  • start by drawing two lines at a right angle then draw a quarter circle using your radius measurement (please use a ruler and set square… the below is just a rough sketch!)

  • Measure your required length down from each edge and draw in the bottom curve.

  • Don’t forget to add seam allowance (I did 1.5cm) on all edges apart from the centre front which will be cut on the fold to make a half circle for the front.

Back

The back is pretty much exactly the same pattern as the front but will be cut as two separate pieces so you also need to add seam allowance to that edge.

Waistband

  • I made mine 2.5cm deep – you might want deeper or narrower – just decide on the depth and cut a strip of fabric to your required depth x2 plus seam allowance and the length of your waist circumference plus seam allowance on both ends.
  • Then cut a piece of interfacing the same length but half the depth and iron this to one half of the reverse of the waistband.

Pockets

  • I don’t have much in the way of tips here… I just drew around my hand in a roughly pocket shape and cut out two sets!
  • Sew the pockets to the side seams –ย this video is quite a good guide.

Putting it all together!

  • Join the side seams and finish the edges however you prefer.
  • Pin the skirt to the waistband evenly and stitch.
  • Insert zip (!) and stitch back seam. The technique for inserting your zip will vary depending on what type of zip you use. You should be able to find a guide to suit you on Pinterest or Youtube. If you’re new to zips I would recommend practising on scrap fabric first.
  • Clip into skirt top if necessary to ensure the waistband sits flat.
  • Fold half of the waistband over to the back, tuck under the raw edge and hand-stitch in place along all edges.
  • Sew up the hem and you’re done!

This is just a quick guide and I’m not an expert – so if you have a play and add any improvements please do let me know in the comments.

I’m planning to fill my wardrobe with lots of swooshy circle skirts!

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s